GE 16223870 - Manual (Page 11)

11
I
NSTALLING THE
P
HONE
1. Choose an area near an electrical outlet and telephone wall jack (RJ11C).
2. Plug the AC power converter into an electrical outlet and the DC
connector into the power jack on the back of the base.
CAUTION: Use only the ATLINKS USA, Inc. power supply 5-2596 that
came with this unit. Using other power supplies may damage the unit.
3. Install the handset battery in each handset.
NOTE: You must connect the handset battery before use.
• Push down on the top of the battery compartment cover (located on the
back of the handset) and slide the cover off.
• Lift the battery pack and connect it's plug to the jack inside the
compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the
jack inside the compartment as shown in the illustration.
• Slide the battery compartment cover back into place.
4. Connect the telephone line cord by plugging one end of the telephone
line cord into the jack on the back of the base and other end into a
telephone wall jack.
NOTE: One base can support up to four handsets.
5. Place a handset in the base cradle. The charge/in use indicator turns on
to indicate the battery is charging.
BLACK WIRE
RED WIRE
BATTERY
PRESS DOWN
FIRMLY