Grizzly G9985 - Manual (Page 10)

-8- G9984/G9985 Oscillating Belt Edge Sander
Unpacking
The Model G9984/G9985 is shipped from the
manufacturer in a carefully packed carton. If you
discover the machine is damaged after you have
signed for delivery, immediately call Customer
Service for advice.
The Model G9984/G9985 has two lifting rings
located on the top of the access door as shown in
Figure 3 .
When using a lifting apparatus to move the
machine, always lift from both of these designat-
ed rings. Lifting at any other location, or from only
one ring at a time, could cause the machine to
become unbalanced and tip over. A hydraulic pal-
let jack or fork lift can also be used. Damage from
improper moving methods may void the warranty.
Keep the lifting rings in a safe location where they
will not become lost. These rings will need to be
re-installed if the machine is ever to be lifted and
moved in the future.
When the machine is in its final location, replace
the lifting rings with the star knobs as shown in
Figure 4 . Be sure to place the 10mm flat washers
and 10mm lock washers on the star knobs thread-
ed post before installing. These washers help the
star knobs remain secure and protect the finish of
the machine.
Figure 3. Lifting ring.
Figure 4. Star knob installation.
1 of 2
Lifting
Rings
Lifting Ring
Locations
Failure to lift and move
the machine correctly
could result in serious
personal injury and/or
damage to the machine