Grizzly AC/DC STICK/TIG WELDER H8154 - Manual (Page 9)

Model h8154 (Mfg. 11/06+)
-7-
SECTION 2: CIRCuIT REQuIREMENTS
Circuit Requirements
Amperage Draw
the Model h8154 welder draws the following
amps under maximum load:
draw at 220V, single phase ...............23.8 Amps
Circuit Requirements
the power supply circuit for your machine Must
be grounded and rated for the amperage given
below. never replace a circuit breaker on an exist-
ing circuit with one of higher amperage without
consulting a qualified electrician to ensure compli-
ance with wiring codes.
If you are unsure about
the wiring codes in your area or you plan to
connect your machine to a shared circuit, con-
sult a qualified electrician.
Minimum 220V Circuit requirement .....30 Amps
plug/Receptacle Type
recommended plug/receptacle ....nEMA l6-30
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
220v Operation Grounding
in the event of an electrical short, grounding
reduces the risk of electric shock. the grounding
wire in the power cord must be properly connected
to the grounding prong on the plug; likewise, the
outlet must be properly installed and grounded.
All electrical connections must be made in accor-
dance with local codes and ordinances.
Electrocution or fire could
result if this machine is
not grounded correctly
or if your electrical con-
figuration does not com-
ply with local and state
codes. Ensure compliance
by checking with a quali-
fied electrician!
Extension Cords
We do not recommend the use of extension cords.
instead, arrange the placement of your equipment
and the installed wiring to eliminate the need for
extension cords.
if you find it absolutely necessary to use an exten-
sion cord at 220V with your machine:
• use at least a 10 gauge cord that does not
exceed 50 feet in length.
• the extension cord must also contain a
ground wire and plug pin.
• A qualified electrician Must size cords over
50 feet long to prevent damage to the weld-
er.
figure 4. nEMA l6-30 plug and receptacle.