Installation instructions, Step 9 connect drain line, Step 10 connect electrical – GE ZBD6905 User Manual

Page 12

Advertising
background image

Installation Instructions

12

STEP 9 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES AND ORDINANCES.

• The dishwasher is supplied with a 72" long drain hose.
• If a longer drain hose is required, add up to 48” of

length for a total of 10 ft. length.

• Secure the drain hose to the air gap, waste tee or

disposer with clamps.

• Make sure drain hose is not kinked.

IMPORTANT:

When connecting

drain line to disposer, check to be
sure that drain plug has been
removed. DISHWASHER WILL
NOT DRAIN IF PLUG IS LEFT
IN PLACE.

STEP 10 CONNECT ELECTRICAL

FOR DIRECT WIRE ONLY
(If a power cord with plug is used, plug it into the wall
outlet and continue with next step.)

Verify that power is
turned off at the
source.

Insert power cord wires
through strain relief and
tighten.

Method 1 – Air gap with waste tee or disposer

• Locate the three dishwasher wires, (white, black and

green) with stripped ends. Insert wire through the
small hole in the junction box. Use wire connectors to
connect incoming ground to green, white to white and
black to black.

• Install junction box cover with screws provided. Check

to be sure that wires are not pinched under the cover.

• Reinstall Insulation Board in position. The board

should be secured so it does not interfere with door
opening.

Method 2 – High drain loop with waste tee or disposer
Waste Tee Installation

Disposer Installation

Waste Tee Installation

Fasten to underside

of countertop

30"

Min.

12"

Min.

12"

Min.

Fasten to underside
of countertop

30"

Min.

Disposer Installation

Waste Tee Installation

If house wiring is not 2-wire with
ground, a ground must be provided
by the installer. When house wiring is
aluminum, be sure to use UL Listed
anti-oxidant compound and alumi-
num-to-copper connectors.

Remove

Plug

White

Ground

Black

Si l’installation électrique de la maison
n’est pas à deux fils plus terre,
l’installateur doit installer un fil de
mise à la terre. Si l’installation
électrique de la maison est en alu-
minium, il faut prendre soin d’utiliser
des composés antioxydants et des

AVERTISSEMENT

connecteurs aluminium à cuivre sur la liste UL.

Advertising
This manual is related to the following products: