GE CGS980 - Manual (Page 38)

Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the range at the
main fuse or circuit breaker panel. Be sure to let the
light cover and bulb cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly push
back the wire cover holder. Lift off
the cover.
Do not remove any screws to remove
the cover.
Do not touch hot bulb with a wet
cloth. Replace bulb with a 40-watt
household appliance bulb.
To replace cover:
Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds
the cover firmly. Be certain the wire
is in the depression in the center of
the cover.
Connect electrical power to the range.
Wire cover holder.
Removable Lower Oven Drawer Pan
NOTE: Allow lower oven drawer to cool before
removing pan.
NOTE: Wipe spills promptly after each use.
■
Never place, use or self-clean the lower
oven drawer pan in the upper oven.
■
Lower oven drawer has a removable pan
for easy cleaning. Clean with hot soapy
water and a sponge or dish towel. Dry
with a clean cloth. An oven cleaner, such
as Easy-Off
® , may also be used. Be sure to
follow the directions on the oven cleaner.
Replace the pan in the lower oven
drawer.
NOTE: Before performing any adjustments,
cleaning or service, disconnect the range electrical
power supply at the household distribution panel by
removing the fuse or switching off the circuit
breaker. Make sure drawer heating element is cool.
Removable Lower Oven Drawer
Most cleaning can be done with the drawer
in place. However, the drawer may be
removed if further cleaning is needed. Use
soap and warm water to thoroughly clean.
To remove the drawer:
Pull the drawer straight out until
it stops.
Press the tabs on both sides in while
pulling the drawer forward and free.
To replace the drawer:
Place the left drawer rail around the
inner left rail guide and slide it in
slightly to hook it.
Place the right drawer rail around the
inner right rail guide and slide it in
slightly to hook it.
Slide the drawer all the way in.
NOTE: Before performing any adjustments,
cleaning or service, disconnect the range electrical
power supply at the household distribution panel by
removing the fuse or switching off the circuit
breaker. Make sure drawer heating element is cool.
38
Care and cleaning of the range.
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support