GE JGP389 - Manual (Page 27)

27
CONVERTING TO LP GAS
or Converting Back to Natural Gas from LP
CONVERT THE PRESSURE REGULATOR
1. Use an adjustable wrench to remove the cap
from the pressure regulator.
2. Apply sideward finger pressure to remove
the plastic pin from the metal cap.
3. Push down on the disc edges to replace the
pin in the cap.
HINT: To turn the pin over, place the cap on
a flat surface and press the pin sideways with
your fingers.
WARNING: Do not remove the pressure
regulator.
2
HOW TO CONVERT FOR USE WITH
LP GAS OR NATURAL GAS
This cooktop leaves the factory set for use with
natural gas. If you convert to LP gas, keep these
instructions and orifices in case you want to convert
back to natural gas.
The conversion should be done by a qualified
technician or installer.
TOOLS REQUIRED:
1/2" open-end wrench
Flat blade screwdriver (small)
Nut drivers: 5/16" or a small adjustable
(depending on the size of the spuds)
PREPARE COOKTOP FOR
CONVERSION
(1) Turn off gas supply at the wall.
(2) Turn off the electrical power to the cooktop.
1
Pressure Regulator
Wiring Box Cover
NAT
NAT
LP
LP
Converter
cap and pin
(continued next page)