Grizzly H8215 - Manual (Page 7)

Model H8215 6" Dual Action Air Sander -5 -
Operation
1. Connect the tool to compressed air
regulated at 90 PSI.
2. Hold the sander firmly and press the
throttle lever ( Figure 3) to turn it ON.
Daily Maintenance
The dual action sander MUST have 2-6
drops of oil directly dropped into the air
fitting before and after each use. A filter
regulator set up
is recommended, however
an in-line lubricator is not recommended
as excess oil in the tool could spray onto
the workpiece.
Run the sander for a few minutes to eject
excess oil, then wipe the tool down with a
rag and begin sanding. Oil the tool after
use or storage.
These procedures should be done after
each use:
• Wipe the housing and tool bits with
a dry cloth, or blow off the dust and
debris with compressed air.
• Check for damage to tooling, hoses,
housing or other accessories.
ACCIDENTAL
START HAZARD!
Disconnect before
service or tool
changes.
AIR PRESSURE
HAZARD!
Never exceed 120
PSI.
LUNG/EAR
INJURY HAZARD!
Wear protective
equipment when
using this tool.
EYE INJURY
HAZARD!
Wear protective
equipment when
using this tool.
3. Turn the regulator knob (Figure 3) to
adjust the speed of the sanding disc.
4. Remove pressure on the throttle lever
to stop the sander.
5. When the sandpaper loses its effective-
ness, remove sandpaper from the pad
and install a new disc.
6. To avoid accidental starting, discon-
nect the sander from the air supply
when it is not in use or when perform-
ing maintenance.
Throttle Lever
Regulator
Knob
Figure 3. Sander controls.