Generac Guardian Series Residential Standby Generators Air Cooled Gase Engine 005883-1 - Manual (Page 5)

5 of 5
®
Generac Power Systems, Inc. • S45 W29290 HWY. 59, Waukesha, WI 53189 • generac.com
©2012 Generac Power Systems, Inc. All rights reserved. All specifications are subject to change without notice. Bulletin 0197530SBY-A Printed in U.S.A. 11/06/12
731.9
[28.8]
637.6
[25.1]
LEFT SIDE VIEW
642
[25.3] 76.2 [3.0]
PEA GRAVEL
MINIMUM
TRANSFER
SWITCH
8KW - 17KW
(IF SUPPLIED)
TRANSFER
SWITCH
20KW
(IF SUPPLIED)
1218
[47.9]
FRONT VIEW
1226
[48.3]
H2
H1
W1
W2
H2
H1
W1
W2
Design and specifications subject to change without notice. Dimensions shown are approximate. Contact your Generac dealer for certified drawings. DO NOT USE THESE DIMENSIONS FOR INSTALLATION PURPOSES.
®
Model # Product Discription
5819 26R Wet Cell Battery
Every standby generator requires a battery to start the system. Generac offers the
recommended 26R wet cell battery for use with all air-cooled standby product.
6212 Cold Weather Kit
If the temperature regularly falls below 32° F, install a cold weather kit to maintain
optimal battery temperature. Kit consists of battery warmer with thermostat built
into the wrap.
5621
Auxiliary Transfer Switch
Contact Kit The auxiliary transfer switch contact kit allows the transfer switch to lock out a
single large electrical load you may not need.
5839 Fascia Base Wrap Kit
The fascia base wrap snaps together around the bottom the new air cooled
generators. This offers a sleek, contoured appearance as well as offering protection
from rodents and insects by covering the lifting holes located in the base.
5703 Paint Kit Bisque Kit
5662 - 8kW
5663 - 10kW
5664 - 14kW
Scheduled Maintenance Kit
Generac's scheduled maintenance kits provide all the hardware necessary to
perform complete routine maintenance on a Generac automatic standby generator.
5928 Nexus Wireless Remote
Completely wireless and battery powered, Generac's Nexus wireless remote monitor
provides you with instant status information without ever leaving the house. Not
compatible with CorePower or EcoGen systems.
5951
Advanced Nexus Wireless
Remote
Remotely control generator functions with the advanced model's LCD display. In
addition to remote testing of the generator, set the excercise cycle and maintenance
interval reminders. Not compatible with CorePower or EcoGen systems.
5937
DLM Load Control DLM
Module (50 Amps)
DLM Modules are used in conjunction with the Nexus Smart Switch to increase
its load management capabilities. It gives the Nexus Smart Switch additional load
management flexibility not found in any other transfer switch. Not compatible with
EZ Switch™.
8/10/14kW available accessories
dimensions
®
8/10/14kW