Grizzly G0657/G0658 - Manual (Page 33)

G0657/G0658 Benchtop Lathe
-31-
Symptom Possible Cause Possible Solution
Vibration noise
while machine
is running; noise
remains constant
when speed is
changed. 1. Dented fan cover on motor. 1. Replace or adjust fan cover. Inspect motor fan and
replace if damaged.
Motor is running but
spindle is not turn-
ing. 1. Belt is loose, broken, or has come off pul-
leys.
1. Inspect belt and tighten, reinstall, or replace if dam-
aged.
Excessive vibration. 1. Workpiece mounted incorrectly.
2. Workpiece warped, out of round, or is
flawed.
3. Spindle speed is set too fast for mounted
workpiece.
4. Lathe is resting on an uneven surface.
5. Motor mount bolts are loose.
6. Belt is worn or damaged.
7. Spindle bearings are worn.
1. Re-mount workpiece, making sure that centers are
embedded in true center of workpiece.
2. Cut workpiece to correct, or use a different
workpiece.
3. Reduce the spindle speed.
4. Shim or adjust feet to remove any wobbles.
5. Tighten motor mount bolts.
6. Replace belt.
7. Replace spindle bearings.
Chisels grab or dig
into workpiece. 1. Tool rest set too low.
2. Tool rest set too far from workpiece.
3. Wrong chisel/tool being used.
4. Chisel/tool dull.
1. Set tool rest higher. See Page 26 for how to prop-
erly set the tool rest height.
2. Move the tool rest closer to the workpiece. See
Page 26 for the proper workpiece/tool rest clear-
ance.
3. Use the correct chisel/tool; educate yourself by
reading books, trade magazines, or seeking help
from an experienced lathe operator.
4. Sharpen or replace the chisel/tool you are using.
Bad surface finish. 1. Wrong spindle speed.
2. Dull chisel or wrong chisel being used for
the operation.
1. Use trial-and-error to find a better spindle speed.
2. Sharpen chisel or try a different chisel.
Tailstock moves. 1. Tailstock mounting bolt loose.
2. Too much clamping pressure applied by
tailstock.
3. Bed surface is oily or greasy.
1. Tighten.
2. Apply less clamping pressure with tailstock.
3. Clean bed surface to remove oil/grease.
Spindle RPM dis-
play is not function-
ing. 1. Spindle RPM sensor is misaligned from
sensor ring.
1. Align sensor ring to RPM sensor and set gap to
approximately
1 /
16
".
Can't remove
tapered tool from
tailstock barrel. 1. Tailstock barrel had not retracted all the
way back into the tailstock.
2. Debris was not removed from taper before
inserting into barrel.
1. Turn the barrel handwheel until it forces taper out of
barrel.
2 . Always make sure that taper surfaces are clean.