Grizzly H6329 - Manual (Page 10)

Model h6329 2 1 ⁄
2
gallon paint tank -8 -
read the manual before operation.
become familiar with this tool, its
safety instructions, and its operation
before beginning any work. serious
personal injury may result if safety
or operational information is not
understood or followed.
to use the paint tank:
1. open the vent valve (figure 6) to
exhaust any tank pressure, and observe
the tank regulator gauge (
figure 5) to
make sure the tank un-pressurized.
2. open the lid. Mix and strain your paint
into the tank.
3. Wipe a thin layer of petroleum jelly onto
the rubber lid seal, and secure the lid
to the tank by tightening the four wing
nuts in an alternating pattern.
4. Close all three valve levers on the tank
( figure 4), and rotate the tank regula-
tor knob two turns counterclockwise.
5. Connect air pressure to the tank, and
slowly open the tank supply air valve.
Adjust the regulator knob so the pres-
sure is within 10-45 psi.
6. open the gun air supply valve, and
adjust the gun regulator (if equipped) to
the manufacturer's recommended psi;
typically no more than 60 psi.
7. open the paint supply valve and begin
making some test sprays. Fine tune the
paint gun and the air pressure settings
to achieve your desired results.
8. periodically rotate the crank handle to
mix the paint.
not designed for use with highly
abrasive, corrosive, or rust inducing
materials. also avoid using lacquer
in the tank, as it will ruin the teflon
coating.
NOTICE
figure 5. paint tank connect to air compressor and spray gun.
Air
Compressor
Gun air supply
ON/OFF valve.
Gun regulator setting
as specified by gun
manufacturer. Typically
never exceed 60 PSI Max.
Paint supply
ON/OFF
valve
Water
separator.
120 PSI Max. 120 PSI Max.
10 to 45 PSI Max.
Tank regulator
setting is typically
10 PSI. NEVER
exceed 45 PSI Max.
120 PSI Max.
Tank air
supply
ON/OFF
valve.
eXplosion hazard!
never exceed 45 psi when pres-
surizing the tank.
operation