Grizzly H6329 - Manual (Page 11)

-9 - Model h6329 2 1 ⁄
2
gallon paint tank
cleaning and lubrication
3. open the tank lid.
4. empty and clean the tank of all paint,
and fill it with 1 quart of solvent.
5. replace the lid, tighten the clamps,
and spray the gun until it sprays clean
solvent.
note: Check with local laws regarding
this practice. Spraying solvents into
the air may be illegal in your area. A
cabinet style spray gun cleaner may be
required.
6. Wearing safety goggles and gloves,
use solvent to thoroughly rinse all parts
that came in contact with the material,
blow out ports with compressed air and
let air dry.
7. Make sure all the fittings on the tank
and regulator, valve, and material hose
are free of hardened material that
could prevent free movement of air.
proper cleaning is the best way to ensure
trouble free performance from your paint
tank. if your tank is not thoroughly cleaned,
damage and poor operation will result.
problems caused by improper cleaning will
not be covered by the warranty. Clean the
tank immediately after each use.
to clean the paint tank:
1. disConneCt the Air supply
FroM the tAnK!
eXplosion hazard! removing the
lid while the tank is pressurized could
result in lid being thrown violently
from tank, causing serious personal
injury. always shut off air pressure
at source and bleed off all pressure
in tank before removing lid.
2. open the vent valve (figure 6) to
exhaust any tank pressure, and observe
the tank regulator gauge (
figure 6) to
make sure the tank is un-pressurized.
cleaning the tank
figure 6 . regulator and vent valve.
tank
regulator
and
gauge
vent valve