Goldmund Reference II Turntable - Manual (Page 5)

The Goldmund Reference II – Assembly manual 5
3 TURNTABLE ASSEMBLY
STEP 2
Box 2: the Table top
Unscrew and remove the top cover of the wood box n°2.
Remove the protection cover,
Mount the table top on the base with the control panel keyboard facing the front.
Then, unscrew the cover hiding of the electronics cables below the table.
Free the control panel cables from the base bottom and run all cables through
base.
STEP 1
Box 1: the base (feet assembly)
Unscrew and remove the top of the wood box n°1.
Remove the protection cover.
Unscrew and remove a side of the wood box.
Free the feet base and position it at its definitive location, the red bar on the back.
Note:
Make sure the small screen is facing toward the front, with both central pointes
bolt on the back.
BACK
FRONT