Grizzly T23092 - Manual (Page 9)

Model t23092 high-pressure spray gun -8 -
14. Maintain an even speed when spraying
and overlap each stroke by 50%. this
will ensure even coverage, as shown
in on the left of
figure 5. overlapping
less than 50%, as shown on the right,
may lead to missed spots or streaky
results.
6"
12"
Correct Incorrect
figure 5. overlapping technique.
15. the spray stroke should have even
consistency and parallel edges. if it
does not, refer to
troubleshooting on
page 12.
atomizing cap
adjustment
to ensure good spraying results, the atom-
izing cap must be correctly orientated for
the direction of the stroke pattern—either
horizontal or vertical.
spraying in the wrong direction may lead
to material build-up on the atomizing cap
horn. Many performance problems are
caused by clogged atomizing holes. in this
case, clean the spray gun (see
ceaning
on page 10)
if the stroke pattern is side-to-side,
the horns of the atomizing cap must
be arranged horizontally, as shown in
figure 7.
Conversely, if the stroke pattern is up-and-
down, the atomizing cap horns should be
vertical, as shown in
figure 8.
pattern control
the pattern control knob on the rear of
the gun body controls the spray output
between a round pattern and a wide fan,
as illustrated in
figure 6.
figure 6. range of spray patterns.
figure 8. Atomizing cap set up for up-and-
down stroke pattern (front view).
figure 7. Atomizing cap set up for side-to-
side stroke pattern (front view).