Grizzly 38" LAWN SWEEPER T10043 - Manual (Page 8)

-8-
T10043 38" Lawn Sweeper
Figure 26. Brush assembly (end view).
Brush
Rotation
Brush
Rotation
Remove
Overlap Bristles
With extensive use, the brushes on the Model
T10043 may become worn and require replace-
ment.
To replace the brushes:
1. Tilt the sweeper all the way forward to allow
easy access to the brushes. For the sake of
simplicity, only replace one brush at a time.
2. Remove the lock nuts and hex bolts indicated
in Figure 26, and remove the old brushes.
It is not necessary to remove the bolts and
nuts connecting the brush holder to the brush
shaft.
2. Remove the retaining clip from the brush
shaft, then remove the spacers ( Figure 24).
Figure 25. Ratchet gear assembly.
Ratchet Gear
Ratchet Pin
Brush Shaft
4. Thoroughly clean, then grease the parts
using multi-purpose grease. Re-assemble in
the reverse order from disassembly.
5. Repeat for the other wheel.
3. Remove the ratchet gear, the spacers on
either side of the ratchet gear, and the ratchet
pin (
Figure 25).
Figure 24. Ratchet gear assembly.
Ratchet Gear
Retaining Clip
Brush Shaft
Ratchet Gear
Spacers
3. Install the new brush, making sure the over-
lap bristles are properly oriented in relation-
ship to the direction of brush rotation, as
shown in
Figure 26. Tighten the hex nuts.