Gateway E-3200 - Manual (Page 28)

System Components 19
9. Reconnect the power cord and turn on the system. Your system
automatically boots to a configuration mode in the Setup utility. Once
in this mode, you can set the correct processor speed.
10. Make your selections and exit, saving your changes.
11. Turn off the system and disconnect the power cord.
12. Open the case, observing the “Static Electricity Precautions” on
page 2.
13. Move the jumper back to its normal position connecting pins 1-2.
14. Close the case, as described in Chapter 1.
15. Reconnect the power cord and turn on the system.