Falcon 210 GEO T DL - Manual (Page 21)

21
You will need the following equipment to complete the
cooker installation satisfactorily
STABILITY BRACKET
If the cooker is to be supplied
with gas through a flexible
hose, a stability bracket or
chain must be fitted.
These are not supplied by with the cooker
but are available at most builders’ merchants.
GAS PRESSURE TESTER
FLEXIBLE GAS HOSE
Must be in accordance
with the relevant
standards.
MULTIMETER
(for electrical checks)
You will also need the following tools:
1. Electric drill
2. Masonry drill bit (only required if fitting the cooker
on a stone or concrete floor)
3. Rawlplugs (only required if fitting the cooker on a
stone or concrete floor)
4. Steel tape measure
5. Cross head screwdriver
6. Flat head screwdriver
7. 4mm & 3mm Allen keys
8. Spirit level
9. Pencil
10. Adjustable spanner
11. Screws for fittingstability bracket
Positioning the Cooker
The diagrams show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
*door opening width
The hotplate surround should be level with, or above,
any adjacent work surface. Above hotplate level a gap
of 75mm should be left between each side of the cooker
and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal
or ceramic tiles) this can be reduced to 25mm.
A minimum space of 800mm is required between the top
of the hotplate and a horizontal combustible surface.
Any cooker hood should be installed in accordance with
the hood manufacturer’s instructions.
Surfaces of furniture and walls at the sides and rear
of the appliance should be heat, splash and steam
resistant. Certain types of vinyl or laminate kitchen
furniture are particularly prone to heat damage
and discolouration. We cannot accept responsibility
for damage caused by normal use of the cooker to
any material that de-laminates or discolours at
temperatures less than 65°C above room temperature.
For safety reasons curtains must not be fitted
immediately behind the cooker.
We recommend a gap of 910mm between units to
allow for moving the cooker. If a flush fit is required, fit
the cooker up to the unit at one side then fit the unit
the other side. Do not box the cooker in; it must still be
possible to move the cooker in and out for cleaning and
servicing.
A clearance of 130mm is required if the cooker is near a
corner of the kitchen to allow the oven doors to open.