Falcon 210 GEO T DL - Manual (Page 22)

22
Unpacking the Cooker
Do not take any packaging off the cooker until it is
directly in front of the place it is to be installed (unless it
will not fit through a door in its outer packaging).
IMPORTANT
Remove plastic coating from hotplate before use.
There may be blemishes visible on the stainless steel
when the protective coating is removed. This can be
caused by moisture and condensation during storage.
We recommend cleaning the stainless steel with Kuhn
Rikon’s ‘Swiss Cleaner’.
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the floor covering is firmly fixed, or removed
to prevent it being disturbed when moving the cooker
around. You will need the levelling tool.
From the back tilt the cooker forward and remove the
rear half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base.
LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut
as shown below.
Make 10 complete (360º) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker. Open the grill door and
the Tall oven door. Grip under the fascia panel and lift
the front of the cooker.
Carefully push the cooker backwards close to its final
position leaving just enough space to get behind it. Take
care not to damage the power cable.
Do not use the door handles or
control knobs to manoeuvre
the cooker.
Use the hotplate and griddle
bowl areas.
Remove the pack base tray.