Gefen EXT-HDMI1.3-CAT6-4X - Manual (Page 9)

5
SENDER PANEL DESCRIPTIONS
1 Standby Button
Sets the 4x CAT6 Extender for HDMI into Standby Mode.
2 IR Sensor
Receives signals from the IR Remote Control.
3 Power Indicator
This LED will turn bright red once the locking power supply has been properly
connected.
4 IR Blaster (4)
Used to connect the IR Blaster to the Source device.
5 CAT6 Output Jack (4)
Connects the Sender unit to the Receiver unit using CAT-6.
6 RS-232 Serial Port (Input)
The 4x4 Matrix may be switched remotely using serial communications with
any offi ce computer or a control automation device by connecting to this port.
Please see page 20 for details.
7 Locking HDMI Port (4)
Connect a HI-Def source to this HDMI port.
8 IP Control
Connect to this port to control the 4x CAT6 Extender for HDMI using IP Control.
See page 25 for more information.
9 RS-232 Serial Port (Output)
Connects to the RS-232 control device. The 4x4 may be switched remotely
using this port. See page 20 for details.
10 24V DC Power Connector
Connects the included 24V DC power supply to this receptacle.