Grizzly H2854 - Manual (Page 9)

H2854 1 H.P. Variable Speed Plunge Router
-7-
SECTION 4: ASSEMBLY
Beginning Assembly
Most of your Model H2854 has been assembled
at the factory, but some parts must be assembled
or installed after delivery. We have organized the
assembly process into steps. Please follow along
in the order presented here.
TOOLS REQUIRED: Phillips ® and flat head screw
driver, 4mm Allen ® wrench (supplied), 19mm
open end wrench (supplied).
The two handles supplied with your router come
unattached from the main unit. You will need to
thread them into the mounting holes located on
both sides of the upper router base as shown in
Figure 2 . When you want to store the router in its
case, the handles will need to be removed and
threaded back into the case mounting locations.
Handles
Figure 2. Installing handles.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
!
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
Be careful not to over-tighten the handles
when installing them into the router unit.
The threads can become stripped if exces-
sive force is used.
NOTICE