GE Answer-Phone 2-9892 - Manual (Page 22)

22
GE 2 9892 5 x 7 08/2/94 BOOKS folder
FONTS: Helvetica, Helvetica Bold, Century Schoolbook
REMOTE OPERATION
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
• When you call your Answer-Phone TM from another location using
a touch-tone phone, you must enter your three digit security
code. (This code is factory preset and written on the bottom of
the unit.) You then can listen to your messages or enter a
command to request one of the other features normally available
to you at home. For future reference write your three digit
security code in the spaces provided on your remote card found
in the fold out in this book.
Notes: Remote functions will not work with rotary, or push button
pulse dialing phones.
After a remote command is completed you will hear three short
beeps. You have ten seconds to enter a new command or hang
up.
You can press any key from a touch tone phone while the
outgoing message is playing to bypass the announcement. The
unit plays a melody then a transfer tone when bypassed. You
may leave a message or dial the three digit security code to
enter remote operations. B. Outgoing
Announce-
ment (OGA)
Bypass
A. Introduction
To Play Messages from a remote location
1. Dial phone number of Answer-Phone
TM .
• After (OGA) unit will play a melody followed by a beep.
2. Dial three digit security code after beep.
• Unit will beep once and voice will say “PLEASE WAIT” then
unit will rewind to the beginning of the messages and play
them back.
3. Unit will beep three times when finished.
4. You will have ten seconds to enter another remote command
or hang up.
To Replay Messages
1. Press
2 to replay messages.
2. Unit rewinds tape.
3. Unit will play messages.
• Press 2 again while unit is playing to quit playback.
• Press 1 and hold to rewind, release to continue.
• Press 9 to fast forward, release to continue.
4. Unit will beep three times when finished.
C.
Remote
Message
Playback