Grizzly H8233 - Manual (Page 9)

Model H8233 3-Piece Framing/Brad Nailer & Stapler Kit -7 -
The Model H8233 is designed to be oper-
ated at the following air pressures using
clean, dry, regulated, compressed air:
Tool Operating Air Pressure
Framing Nailer ......................... 80–110 PSI
Brad Nailer .............................. 60–100 PSI
Stapler ..................................... 60–100 PSI
DO NOT exceed the 120 PSI maximum
operating pressure for your nailer/sta-
pler.
Before using your new nailer/stapler, regu-
late the air pressure to find the optimum
setting within the specified operating
range. Start by testing the nailer/stapler at
a low setting, then increase the air pres-
sure as needed for satisfactory results.
An in-line filter/lubricator/regulator unit can
be installed, as depicted in
Figure 2.
This filter/lubricator/regulator unit will
protect your tool from damaging water
build-up, allow you to adjust and maintain
constant air pressure to your tool, and
save you the inconvenience of having to
manually lubricate your tool every time
you use it.
Compressed Air
System
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Exceeding the maximum permissible
operating pressure may damage the
nailer/stapler and cause it to malfunc-
tion. To protect yourself from personal
injury, DO NOT allow the air pressure
to exceed the recommended pressure
for these tools!
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2. Typical filter/lubricator/regulator installation order.