Grace Digital MINI-BULLETS II GDI-AQBLT300 - Manual (Page 5)

red POWER LED will illuminate together. If the blue SIGNAL LED does not
V power adaptor to the DC input jack on the bottom of
each speaker, then plug into the power wall outlet. You may also insert 6 x ‘AA’
illuminate, ensure the audio source is turned on and properly connected to the
jack.
SPEAKER (RECEIVER)
1. Connect the 12
size ALKALINE batteries into the battery compartment. Ensure the batteries
polarity (+/-) are correct, at the bottom of the speakers
(batteries not included in the package).
2. Press the POWER button and turn the speakers ON. The POWER LED
ill light up in blue. Switch off the speakers by pressing the POWER
PERATION
w
button on the speaker, and the LED will turn off.
O
. Turn on the audio source to which the transmitter is connected with.
, and the
POWER LED on transmitter will light up .
1
2. Turn on the transmitter by set the POWER switch to ON position
smitter for best perform
location selected.
3. Select between the channels on the tran
ance for the
4. Press the “POWER” button on the speaker to turn on the speaker Press the
“SCAN” AUTO-TUNE button to get the best tuning reception on the speaker.
P.4