Grizzly G1067Z - Manual (Page 20)

G1067Z Wood Lathe -19-
SECTION 5: MAINTENANCE
Lubrication
Bed
The G1067Z Lathe is equipped with a split pulley
system which allows the speed of the lathe to be
changed while its running. To assure the smooth
operation of this pulley system, we recommend
the main spindle and motor spindle be greased
occasionally. To do this, remove the pulley cover,
vacuum out any saw dust and apply grease to the
spots indicated in
Figure 24. Disposable acid
brushes work best to get into these hard to reach
places.
Shielded and pre-lubricated ball bearings require
no lubrication for the life of the bearings. In a con-
tinuous-use environment, expect the bearings to
last for several years. With intermittent use, bear-
ings can be expected to last much longer. All
bearings are common sizes and can be easily
obtained.
The bed and other non-painted surfaces on the
Model G1067Z should be protected against rust
and pitting. Wiping the lathe clean after every use
ensures that moisture from wood dust isn’t
allowed to trap moisture against bare metal sur-
faces.
Make a habit of inspecting your lathe each time
you use it. Check for the following conditions and
repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Any other condition that could hamper the
safe operation of this machine.
General
Figure 24.
Before performing any type of inspection
or maintenance work on this lathe, be sure
that the power cord is unplugged and all
moving parts have come to a complete
stop. Serious personal injury may occur.