Grizzly H8230 - Manual (Page 7)

H8230/H8231 15° Roofing Nailer -5 -
The Model H8230/H8231 is designed
to operate at 70-110 PSI using clean,
dry, regulated, compressed air.
DO NOT
exceed the 120 PSI maximum operating
pressure for your model.
An in-line filter/lubricator/regulator unit,
depicted in
Figure 2, can be installed and
should be located as close to the nailer as
possible.
This filter/lubricator/regulator unit will
protect your tool from damaging water
build-up, allow you to adjust and maintain
constant air pressure to your tool, and
save you the inconvenience of having to
manually lubricate your tool every time
you use it.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2. Typical filter/lubricator/regulator installation order.
Compressed Air
System
Exceeding the maximum permissible
operating pressure may cause the
nailer to explode, blowing metal frag-
ments in all directions. To protect
yourself from serious personal injury,
DO NOT allow your air compressor to
exceed the recommended pressure
when connected to this nailer!