Grizzly Power Feeder G7873 - Manual (Page 16)

-14-
Model g4181/g7873 1-hp power Feeder
the unpainted surfaces are coated with a waxy
oil to prevent corrosion during shipment. remove
this protective coating with a solvent cleaner
or degreaser, such as shown in
Figure ??. For
thorough cleaning, some parts must be removed.
For optimum performance, clean all moving
parts or sliding contact surfaces. avoid chlo-
rine-based solvents, such as acetone or brake
parts cleaner that may damage painted surfac-
es. always follow the manufacturer’s instructions
when using any type of cleaning product.
clean up
Gasoline and petroleum
products have low flash
points and can explode
or cause fire if used to
clean machinery. DO
NOt use these products
to clean the machinery.
Many cleaning solvents
are toxic if inhaled.
Minimize your risk by only
using these products in a
well ventilated area.
G2544—Solvent cleaner & Degreaser
a great product for removing the waxy shipping
grease from your machine during clean up.
Figure ??. Cleaner/degreaser available from
grizzly.
assembly
to correctly position this power feeder on your
table top, completely assemble the power feeder
first in the order of
a, b and c as shown in
Figures 6 and 7. next, refer to base Mounting on
Page ???. With the power feeder unit completely
assembled, it will be easier to locate where on the
table top you will need to drill your base mounting
holes, so you can take advantage of the full range
of power feeder swing and adjustments.
you MuSt assemble all guards, fences, and
holdowns before starting your machine or
power feeder. Failure to heed this warning
could result in serious personal injury.
Figure 7. assembled unit.
C
Figure 6. stand assembly.
B
a