Grizzly Power Feeder G7873 - Manual (Page 17)

Model g4181/g7873 1-hp power Feeder
-15-
position the power feeder on the table top to
determine where to drill your base mounting
holes, so you can maximize power feeder swing
and adjustment options.
there are two mounting options available:
Through Bolt Mounting and Direct Mounting
(discussed on
Page 16). Choose an option that
suits your requirements.
Whichever way you mount your power feeder,
you must be able to use the handcranks and lock
levers to position the rubber wheels parallel with
the table surface and
1 ⁄
8
" lower than the thickness
of your workpiece.
also, you must be able to point the power feeder
slightly towards the machine fence (
Figure 8). in
other words, the tracking of the power feeder must
be toed-in approximately 1° to 1.5° degrees toward
the machine fence so the rubber wheels slightly
push the workpiece against the fence during cut-
ting operations.
;ZZY
;ZZY
Tablesaw Shaper
8jiiZg
;ZZY
Jointer
8jiiZg]ZVY
7aVYZ
;ZcXZ ;ZcXZ
;ZcXZ
)i]"GdaaZg
BdYZah
Figure 8. typical power feed mounting on a shaper, jointer, and tablesaw.
base Mounting