Grizzly H6086 - Manual (Page 18)

-16- Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits
5. Place the remaining inserts into the back
holes.
6. Place the wooden block on an insert and
lightly tap the insert down until it touches the
top of the guitar body. Repeat for the other
insert.
7. Thread the bridge adjustment screws into the
inserts as shown in Figure 25.
Figure 25. Tailpiece adjustment screw.
8. Slide the tailpiece onto the adjustment
screws.
Figure 24. Bridge adjustment screw.
Installing Bridge on
Model H6082/83
Components Needed Qty
Guitar ................................................................. 1
Bridge ................................................................ 1
Stopbar Tailpiece .............................................. 1
Threaded Inserts ............................................... 4
Tailpiece Adjustment Screws ............................ 2
Bridge Adjustment Screws ................................ 2
Tools Needed
Hammer ............................................................. 1
Small Wooden Block ......................................... 1
To attach the bridge to the guitar body:
1. Place two inserts into the forward holes as
shown in Figure 23.
2. Place the wooden block on an insert and
lightly tap the insert down until it touches the
top of the guitar body. Repeat for the other
insert.
3. Thread the bridge adjustment screws into the
inserts, as shown in Figure 24, and place the
bridge over the inserts.
4. Feed the grounding wire from the electronics
cavity into the back hole. Hook the end of
the wire down so it catches the edge of the
hole.
Figure 23. Threaded insert placement.