Grizzly H6086 - Manual (Page 23)

Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits -21-
Winding Strings on
the Model H6086
The correct position of the guitar strings is shown
in
Figure 31. The thin High E string is the "1st"
string and the thick Low E string is the "6th".
Components Needed Qty
Strings ............................................................... 6
Tools Needed
Wire Cutters .......................................................1
Hex Wrench 3MM ...............................................1
Figure 31. Correct string locations.
�
�
�
�
�
�
����
�
�
�
�
�
����
Figure 34. Bridge components.
To install the guitar strings:
1. Cut the ball ends and wraps off of the guitar
strings.
2. Insert the strings between the lock block and
the front edge of the lock box as shown in
Figure 35.
Fine Tuner
Lock Block
3. Tighten the saddle lock screws.
4. Guide the strings over the nut, and through
the hole in the corresponding tuners.
5. Allow only enough slack in the strings for
2-3 rotations around the tuner. Note—If
too much slack is allowed, then the strings
could wind off the machine head after many
successive rotations. If not enough slack is
allowed, then the strings may not hold the
winding tension.
6. Bend the strings at a right angles across the
edge of the machine heads.
7. Rotate the tuners until the strings just begin
to hold the winding tension. Note—DO NOT
tighten the strings beyond the initial tension-
ing at this time. Final tensioning should be
completed during the string tuning process.
8. Use wire cutters to cut off the excess string.
Figure 35. Strings locked into lock box.
Saddle Lock Screw
Lock Box