Grizzly H7507 - Manual (Page 13)

Model h7507 (Mfg. since 3/05)
-11-
Assembly
the Model h7507 mounts on most table saws that
have 27" deep tables. if your table saw does not
have mounting holes that match the router table,
you will need to drill and tap the holes yourself.
also, you may have to modify the fence rails for
mounting the router table. read this entire assem-
bly section before you begin the installation pro-
cedure below to make sure the h7507 will fit your
table saw before making any modifications.
To assemble and install your router table
extension wing:
1. diSConnECt taBlE SaW FroM
poWEr!
2. remove the right extension wing of the saw
table and use the mounting holes shown
in
figure 4 to install the router table in its
place.
( ¿
-
;aViLVh]Zg
( ¿
-

AdX`
LVh]Zg
( ¿
-
"&+m& & ¿
)

=Zm7dai
GdjiZgIVWaZ
BV^cIVWaZ
figure 5. Example of mounting route table to
table saw.
3. With the help of another person to hold the
router table, align the mounting holes in both
tables and secure them together with the (3)
3 ⁄
8
"-16 x 1 1 ⁄
4
" bolts, (3) 3 ⁄
8
" lock washers, and
(3) 3 ⁄
8
" flat washers, as shown in figure 5.
Finger tighten.
4. place the straightedge across the saw table
and router table to make sure that the com-
bined table surface is flat.
— if the combined table surface is flat, con-
tinue with Step 5.
— if the outside edge of the router table tilts
down, place strips of masking tape along
the bottom edge of the saw table to shim
the router table up and even with the saw
table from side to side (see
figure 6).
IVeZ
figure 6. using tape to shim the router table up.
GdjiZgIVWaZ BV^cIVWaZ
Bdjci^c\
=daZh
figure 4. Mounting holes in router table and saw
table.
Note: There are other ways to attach the
router table to a table saw, but these may
require modifications to the saw.