Grizzly H7507 - Manual (Page 17)

Model h7507 (Mfg. since 3/05)
-15-
IgVch[Zg
I]ZhZ=daZh
8ZciZgEd^cih
6a^\cZY
Hjeedgi
7dVgY
figure 18. Fence and board lined up and
clamped to transfer screw hole positions.
6. use the table saw fence face as a template
to transfer the screw hole positions onto your
fence board (
figure 18). use a center punch
or long nail to mark the holes.
7. unclamp the support board and fence face,
and drill holes through the support board
where marked with a
3 ⁄
16
" drill bit.
8. Countersink the holes in the face of the sup-
port board approximately 1 ⁄
4
" deep with a 3 ⁄
8
"
drill bit, as shown in figure 19.
STEP 7
9g^aa
( ¿
&+
]daZh
i]gdj\]i]Z
hjeedgiWdVgY#
STEP 8
8djciZgh^c`i]Z]daZh
Veegdm^bViZan
& ¿
)
YZZe
l^i]V ( ¿
-
Yg^aaW^i#
( ¿
-

( ¿
&+

& ¿
)

;VXZ
IdeK^Zl
figure 19. Steps for drilling and countersinking
screw holes into support board.
9. re-attach the fence face at both ends, as
shown in figure 20.
figure 20. reattaching fence face.
10. attach the support board to the fence with the
#10-24 x 2 1 ⁄
2
" phillips screws included with
the kit, as shown in figure 21.
Note: If you are using a non-Shop Fox
Classic Fence, you may have to provide your
own screws if the ones provided with the kit
are not the correct size and will not secure
the support board to the fence face.
figure 21. attaching support board.