Grizzly G7946 - Manual (Page 12)

-10- G7945/46 Radial Drill Press
The Model G7945 comes with a one piece square
table and support as shown in
Figure 4 . The
Model G7946 comes with a round table and two
piece hinged table support.
1. Insert the pinion gear into the hole on the side
of the bracket from the inside, starting with the
shaft. See
Figure 5 . Align the setscrew in the
crank with the flat portion of the pinion gear
shaft. Secure with a 3mm Allen
® wrench.
2. The rack has teeth that extend farther on one
end than the other. This end must be posi-
tioned down. Insert the rack into the table sup-
port bracket and position in the pocket. Be
sure that the gear teeth are positioned out.
See
Figure 6 .
3. While holding the rack in place, slide the table
support bracket over the column. Allow the
bracket and rack to slide down the column
until the bottom of the rack contacts the shoul-
der of the column support. Secure the table
bracket by tightening the lock handle.
4. Slide the column ring onto the top end of the
column with the inside bevel downward. See
Figure 7 . Move the ring around until the tip of
the rack fits inside the bevel.
Figure 6. Rack orientation (G7946 shown).
Figure 5. Insert the pinion gear from the inside.
Figure 4. G7945 table and support.
Table Support
Figure 7. Inside bevel in the correct position.
NOTICE
Do not over-tighten the setscrew in the col-
umn ring, as it may split the ring.
Pinion Gear
Do not overtighten.