Grizzly G7946 - Manual (Page 17)

G7945/46 Radial Drill Press -15-
Head Adjustments
Figure 16. Guide pin location.
The headstock can be tilted from 45° clockwise to
90° counterclockwise.
1. Loosen the lock handle on the right side of
the headstock.
2. Pull out the guide pin located on the left side
of the headstock and rotate the pin 90°. See
Figure 16 . Tilt the headstock to the desired
angle specified on the scale and tighten the
lock handle on the right side of the head-
stock.
Return to vertical position:
1. Loosen the lock handle located on the right
side of the headstock.
2. Move the headstock to its original position
and move the guide pin back into the guide
slot. Tighten the lock handle.
The headstock can also be adjusted back and
forth:
1. Loosen the lock handle located on the right
side of the headstock.
2. Turn the black ribbed handle to move the
headstock back and forth to desired position.
Tighten the lock handle before operating the
machine.