Grizzly Disc G0724 - Manual (Page 15)

Model g0724 (Mfg. since 09/11)
-13-
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Mounting
figure 5. Example of a "through Mount" setup.
figure 6. Example of a "direct Mount" setup.
Assembly
tools Needed Qty
hex Wrench 4mm .............................................. 1
phillips screwdriver ........................................... 1
to assemble the sander:
1. remove the two cap screws 5mm and
bushings from the table and the sander
assembly, as shown
figure 7.
figure 7. location of cap screws and pointer.
Cap screws
pointer
2. position the angle gauge of the table over
the two cap screw and bushing holes located
above the pointer.
3. install the pilot cap screw on the right side of
the table, attaching it to the sander.
4. replace the two cap screws and bushings
removed in Step 1.
5. install the table tilt lever and washer between
the two cap screws and bushings.
6. set table to 90° (see table tilt Calibration
on page 24), and reinstall the pointer at 0°.
7. rotate the disc by hand and make sure it
turns freely.