GE 00008005 - Manual (Page 48)

48
NOTE: If the memory is full, the handset will prompt FULL when the
SELECT button is pressed in Step 6.
Record with Included Audio Cable or an Optional Headset
Audio Cable: Before recording the ringer tone, make sure that the provided audio
cable is correctly installed into your computer or CD player or TAPE player by inserting
the 3.5mm plug (the larger end of the connector) into the headphone jack of your PC
or audio source, and insert the .5mm plug (the smaller end of the connector) into the
headset jack on the side of your 8041 handset or Optional Model 8011 handset.
Optional Headset: Before recording the ringer tone, make sure that the optional
headset is connected to the headset jack on the side of your 8041 handset or
Optional Model 8011 handset.
From the REC RING TONE menu;
1. Use the 6 or 5 button to scroll to the AUDIO_CABLE or
HEADSET.
. Press the SELECT button to enter.
3. Verify the cable/headset is connected to your handset,
then press the SELECT button again to start the count-
down display. The handset will start recording and the
second number will decrease automatically.
4. The recording will stop when the display counts down
to 0 seconds.
Or you may press the SELECT button any time to stop.
When the recording stops, the display will show  options:
REPLAY and RE-RECORD.
NOTE: After recording, you may also press the
*EXIT button to return to the Sound Setting menu.
To replay the recorded ringer tone:
1. Use the 6 or 5 button to scroll to
REPLAY.
. Press the SELECT button to play the recorded ringer tone.
3. When finished, the display shows both options again.
START
AUDIO CABLE
12 SECONDS
PRESS SELECT TO
AUDIO CABLE
RE-RECORD
REPLAY
MICROPHONE
REC RINGER TONE
HEADSET
AUDIO_CABLE