GE DCL333 - Manual (Page 16)

16
Customer Service
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Customer Service
Troubleshooting T
ips
Installation Instructions
Safety Instructions
Operating Instructions
Customer Service
Troubleshooting T
ips
Installation Instructions
Safety Instructions
Operating Instructions
Installing the dryer.
Electrical Installation for Electric Dryers
WARNING: The following are specific
requirements for proper and safe electrical
installation of your dryer. Failure to follow
these instructions can create electrical shock
and/or a fire hazard.
WARNING: This appliance MUST be properly
grounded. Electrical shock can result if the
dryer is not properly grounded. Follow the
instructions in this manual for proper
grounding.
WARNING: DO NOT use an extension cord with
this dryer. Some extension cords are not
designed to withstand the amounts of
electrical current this dryer utilizes and can
melt, creating electrical shock and/or fire
hazard. Locate the dryer within reach of the
wall outlet, taking into account the length
of power cord to be purchased and allowing
some slack in the cord. Refer to Electrical
Requirements
in this manual for the proper
power cord to be purchased.
WARNING: A UL-approved strain relief must be
installed onto power cord. If the strain relief is
not attached, the cord can be pulled out of the
dryer and can be cut by any movement of the
cord, resulting in electrical shock.
WARNING: Use copper receptacles only.
NOTE: Dryers operating on 208-volt power supply will
have longer drying times than those operating
on 240-volt power supply.
A wiring diagram is located inside the
control panel.
Grounding Requirements
DANGER: Improper connection of the
equipment-grounding conductor can result in a risk
of electric shock. Check with a licensed electrician if
you are in doubt as to whether the appliance is
properly grounded.
Grounding must be in accordance with local codes
and ordinances, or in the absence of local codes, in
accordance with the National Electrical Code
ANSI/NFPA No. 70.
For a grounded, cord-connected electric dryer:
The dryer MUST be grounded. In the event of
a malfunction or breakdown, grounding will
reduce the risk of electrical shock by creating
a path of least resistance for electrical current.
If your dryer is equipped with a power supply
cord having an equipment-grounding conductor
and a grounding plug, the plug MUST be
plugged into an appropriate, copper-wired
receptacle that is properly installed and
grounded in accordance with all local codes and
ordinances. If in doubt, call a licensed electrician.
For a permanently-connected electric dryer:
■ The dryer MUST be connected to a grounded
metal, permanent wiring system; or an equipment-
grounding conductor must be run with the circuit
conductors and connected to the equipment-
grounding terminal or lead on the appliance.
For a cord-connected gas dryer:
■ This dryer is equipped with a three-prong
(grounding) plug for your protection against
shock hazard and should be plugged directly into
a properly grounded three-prong receptacle. Do
not cut or remove the grounding prong from this
plug.
2
1