Grizzly G0656 - Manual (Page 16)

-14-
G0656 8" Jointer with Built-In Mobile Base
Assembly
To assemble the jointer:
1. Carefully lay the stand on its side so you can
access the underside.
2. Bolt the wheel assembly to the stand with the
provided hardware, as shown in Figure 7.
Note: Refer to the Inventory List on Page
11 for a list of components needed for ass-
sembly.
Figure 7. Example of bolting the wheel assembly
to the stand.
3. Turn the stand rightside up.
5. With the help of an assistant, lift the jointer
onto the stand.
6. Align the mounting holes on the jointer and
stand.
7. Secure the jointer to the stand with the M8-
1.25 x 50 cap screws, washers, and hex nuts,
as shown in
Figure 8.
The jointer is heavy. Seek
assistance when lifting it
onto the jointer stand.
Figure 8. Jointer secured to stand.
8. Using a 13mm wrench, loosen the motor
bracket fasteners shown in Figure 9.
Note: DO NOT completely remove the motor
mount bolts.
Figure 9. Motor bracket fasteners (black
arrows); motor mount fasteners (white arrows).
Hex Bolt M8-1.25 x 50
Flat Washer 8mm
Hex Nuts
M10-1.5
Hex Bolts M10-1.5 x 55
Flat Washers 10mm
4. Remove the rear access panel from the
jointer stand.
�������
���������������
���������������
��������������� �����
���������������
����������
������������