Grizzly 10" x 18" benchtop lathe H8259 - Manual (Page 19)

model h8259 mfg. 10/07+
-17-
figure 17. installing live center in tailstock.
Quill lock handle
Quill
handwheel
Quill
Removing/installing
faceplate
To remove faceplate:
1. unplug lathe From poWer!
2. hold the headstock spindle wheel securely
while turning the faceplate counterclockwise
until it is removed. if the spur center is
installed, it will be removed during this pro-
cess.
4. tighten the quill lock handle.
To remove the live center:
1. loosen the quill lock handle (if locked)
approximately half a turn counterclockwise.
2. turn the quill handwheel counterclockwise
until the tailstock quill bottoms out, causing
the live center to be forced out of the quill.
The tailstock quill lock handle must always
be locked down while the lathe is in use. The
workpiece can be thrown from the lathe if
this step is not observed. Also, the tailstock
quill should not protrude from the tailstock
housing more than 2'' or the quill will not be
supported enough. failure to follow these
warnings may result in personal injury.
to mount a workpiece to your faceplate, refer to
Page 20.
To install faceplate:
1. unplug lathe From poWer!
2. thread faceplate onto spindle shaft until it is
secure against the shoulder on the spindle
shaft.
live Center
figure 18. removing faceplate.
headstock
spindle wheel
Faceplate