GE JGP979 - Manual (Page 15)

Control Knobs and Control Panel Seal
After grilling there may be soot on the
knobs and control panel seal. This soot
can be removed by scrubbing with a
plastic scrubber and mild dishwashing
detergent. The control knobs may
be removed for cleaning.
To remove a knob, pull it straight up.
Wash the knobs in soap and water but
do not soak. Avoid getting water down
into the knob stem holes.
Wipe with a sponge, damp cloth or
paper towel. Do not scrub with steel
wool pads or abrasive cleansers.
To replace a knob, match the flat part
of the knob opening with the flat side
of the shaft.
Care and cleaning of the cooktop.
GEAppliances.com
Before Cleaning
Before cleaning any part of your
cooktop, be sure all controls are off
and DISCONNECT ELECTRICAL POWER
TO THE COOKTOP at the fuse box or
circuit breaker panel, or pull the
cooktop power plug, located beneath
the cooktop and inside the cabinets. Do not operate the cooktop without all
parts in place.
Grease Jar
A grease jar is located below the grill
basin pan under the countertop. Check
periodically to prevent spillovers.
Unscrew and remove. If the jar is broken, replace with any
heat tempered jar, such as a canning
jar, which has a standard screw neck.
Porcelain Cooktop
The porcelain enamel finish is sturdy
but breakable if misused. This finish is
acid-resistant. However, any acidic foods
spilled (such as fruit juices, tomato or
vinegar) should not be permitted to
remain on the finish.
If acids spill on the cooktop while it is
hot, use a dry paper towel to wipe it
up right away. When the surface has
cooled, wash with soap and water or
cleansing powders. Rinse well.
For other spills, such as fat spatterings,
wash with soap and water or cleansing
powders after the surface has cooled.
Rinse well. Polish with a dry cloth.
Stainless Steel Surfaces
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use
warm sudsy water, a stainless steel
cleaner such as Kleen King
® , or an all-
purpose liquid or spray cleaner. Always
wash in the direction of the grain. Rinse
thoroughly with a sponge or cloth and
clean water. Dry with a soft, clean cloth.
After cleaning, use a stainless steel
polish, such as Stainless Steel Magic
® ,
Revere Copper and Stainless Steel
Cleaner
® or Wenol All Purpose Metal
Polish ® . Follow the product instructions
for cleaning the stainless steel surface.
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
15