GE 45601 - Manual (Page 16)

Copying Information to this Remote
Place the two remotes near each other.
Refer to the user manual for the primary remote for programming
information. Put the primary remote into programming mode so
that it sends information to the secondary remote. If the primary
remote is a 45601 Advanced Remote, refer to the section above on
Sending Network Information.
On the target 45601, use either Arrow key to scroll until the display
reads TRANSFER.
Press OK and the screen will display PRIMARY.
Use either arrow key to scroll until the display reads RECEIVE,
Press OK and the Screen will display RECEIVING.
When screen displays SUCCESS you have successfully transferred
the information.
PRIMARY CONTROLLER SHIFT (TRANSFER)
You can transfer all of the 45601’s information to another remote, so
it becomes the new primary controller. The 45601 will retain all of its
programming; however, it will now be a secondary controller.
Transferring Primary Controller Information:
Place the two remotes near each other.
On the 45601, press and hold
SETUP until the screen displays LGHT
SETUP.
Use either Arrow key to scroll until the display reads
TRANSFER.
Press OK and the display will read PRIMARY.
Press OK and the display will read ALL.
a. To send network and device information to the new remote,
proceed to Step 6.
b. To send only network information to the new remote, use either
arrow key to scroll to NTWK ONLY and proceed to Step 6.
6. Put the target (new primary) remote into programming mode so
that it receives information from the 45601.
7. On the 45601, press the OK key and the display will read SENDING.
8. When the screen displays SUCCESS, you have successfully
transmitted the information to the new primary controller.
RECOVERING NETWORK INFORMATION
The Recovery function, also known as rediscovery, is used to rebuild the
routing table within the controller. This table identifies which Z-Wave
devices can communicate with other Z-Wave devices on the network
and helps ensure that commands are transmitted and repeated
through the most efficient route to your destination device.
To have your remote recover network information:
Press and hold SETUP until the screen displays LGHT SETUP.
Use either Arrow key to scroll until the display reads NETWORK.
Press OK and the screen will display RESET.
Use either Arrow key to scroll until the display reads RECOVERY.
Press OK.
When the screen displays COMPLETE. You have successfully
recovered network information.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.