GE 2-9950 - Manual (Page 7)

7
W
ALL
M
OUNT
I
NSTALLATION
1. Plug the power supply cord into
the POWER 9V DC jack on the
base and into an AC outlet. The
LED indicators will all light up.
This is normal operation. The
LEDs will go out after about 30
seconds.
Place handset in the base to charge
for 12 hours. The CHARGE/IN USE
light comes on to indicate that the
battery is charging. You must
charge the handset battery
continuously (without using the
phone) for 12 hours when you
set up the phone.
2. Flip the base plate and re-install
it by putting the tabs into the
slots on the top of the unit first,
and then snapping the bottom
tabs into place.
3. Remove the handset hook; turn it
upside down, and put it back in
the slot. You need to do this so
the handset doesn’t fall out of the
base.
4. Plug the short telephone line
cord into the jack marked PHONE
LINE on the back of the unit and
plug the other end into a modu-
lar wall jack.
5. Slip the mounting holes over the
wall plate posts and slide the unit
down firmly into place. (Wall
plate not included.)
3
4
2
1
5