Stovax Steel Manhattan Log Effect Stove Range - Manual (Page 13)

13
5.4 Place log D across from the rear log A to log B on the left-
hand side. There are cut-outs in both logs for location. See
diagram 13.
5.5 There are two ash panels which lay across the front of the
burner skin. Place the panel with the flat edge facing the left
side of the firebox. There are location holes on this log
which fit over the screw holes of the burner skin.
5.6 Place the second ash panel to the right of the first, with the
pointed end of the panel fitting into the V shape. This panel
should locate on the screw holes of the burner skin. Ensure
that both logs are horizontal to the burner ports.
5.7 Place log E across from the rear of log A to log C on the
right-hand side. Again, there are cut-outs for location. The
front of the log should sit on the front ash panels and should
fit tight to log C. See diagram 16.
5.8 Carefully insert the front coal retainer into the front panel of
the firebox. Take care not the scrape/damage the logs. This
coal retainer sits in two brackets. Ensure it is fully inserted,
leaving approximately a 4 mm gap between the firebox
ledge and the bottom of the coal retainer.
5.9 Ensure that the rope seal on the back of the glass frame is
intact. Replace the glass frame making sure that the 8 screws
are tightened evenly. Do not overtighten. See Diagram 18.
INSTALLATION INSTRUCTIONS
18
AR0877
13
AR1613
14
AR1614
15
AR1615
16
AR1616
17
AR1617