Grizzly H0603 - Manual (Page 14)

H0603 18V Cordless Drill and Saw -12 -
SAW OPERATIONS, CON’T
Operating this equipment has the potential to propel debris into the air which can
cause eye injury. Always wear safety glasses or goggles when operating equip-
ment. Be certain the safety glasses you wear meet the appropriate standards of the
American National Standards Institute (ANSI).
Cutting Depth Adjustment:
1. Remove battery.
2. Loosen the black knob to the left and
below the hand grip.
3. Pull or push the saw base to expose
more or less saw blade.
4. To check the depth of cut compare
the blade depth to the workpiece
thickness and adjust saw base until
one half of one tip of a tooth is
exposed past the workpiece. Refer
to Figure 7 & 8 .
5. Tighten the black lock knob.
Adjust saw base so that only one-half of
a tip of one tooth on the blade is
exposed past the thickness of the work-
piece to help avoid potential kick-back .
Fine Tuning Angle of Blade:
1. Remove battery.
2. Adjust the depth of cut so that all of
the blade is exposed below the saw
base.
3. Loosen the black knob located on the
leading edge of the saw.
4. Rotate the saw so the exposed por-
tion of the blade is up. Place a small
square on the base and butt it up
against the blade. Take care that the
square does not come into contact
10
20
30
40
50
Fig 7. Depth of cut adjusted correctly.
Fig 8. Base angle adjustment.
with any carbide teeth.
5. Adjust the base so that the edge of
the square contacts the the full face
of the exposed part of the blade.
6. Tighten the angle locking knob.
90° Stop