Grizzly 7.2 Mini Kit H8124 - Manual (Page 11)

Model H8124 7.2V Mini Grinder Kit -9 -
DO NOT use bits or cutters with a
cutting diameter larger than 1". The
bit or cutter could break apart under
the stresses of high speed use caus-
ing serious personal injury.
Installing Bits
The Model H8124 uses bits and cutters
with a
3 ⁄
32
" or a 1 ⁄
8
" diameter shaft. See
the Grizzly catalog or www.grizzly.com
for a complete listing of available bits and
accessories.
To install a bit:
1. REMOVE THE BATTERY FROM THE
GRINDER!
2. Depress the collet lock (see Figure 3)
and loosen the collet nut with the collet
wrench. The collet lock will engage as
the collet rotates.
Note: It is not necessary to com-
pletely remove the collet nut from the
shaft unless you are also changing the
collet.
3. Insert at least 1 ⁄
2
" of the bit into the
collet.
4. Hand tighten the collet nut while
depressing the collet lock. Then, use
the collet wrench to tighten the collet
nut an additional
1 ⁄
3
turn.
Using the LED Gooseneck Work
Light
The LED gooseneck work light is a hands-
free solution to illuminating low light opera-
tions.
To use the LED gooseneck work light:
1. DISCONNECT THE BATTERY
CHARGER FROM THE AC/DC
ADAPTER!
2. Mount a charged 7.2 NiCad battery into
the battery charger (see Figure 2).
3. Use the small switch on the battery
charger to turn the LED gooseneck
work light ON and OFF.
to install a bit
Collet Lock
Collet Nut
Figure 3. Collet lock.
Switch
Figure 2. LED gooseneck work light with
battery installed.
LED Light