GE Monogram ZDP364LD - Manual (Page 2)

2
Installation Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
— Save these instructions for local
inspector’s use.
• IMPORTANT
— Observe all governing codes and
ordinances.
• Note to Installer — Be sure to leave these instructions
with the Consumer.
• Note to Consumer — Keep these instructions
with your Owner’s Manual for future reference.
• Completion Time — 1 to 3 hours.
• Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the warranty. See Owner’s Manual for warranty
information.
WARNING:
This appliance must be properly grounded. See ”Electric
Supply.”
For Monogram local service in your area, 1.800.444.1845.
For Monogram Service in Canada, call 1.800.561.3344.
For Monogram Parts and Accessories, call 1.800.626.2002.
If you received a damaged range, you should contact your
dealer.
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber or gas
fitter.
• When using ball type gas shut off valves, they shall be
T-handle type.
• A flexible gas connector, when used, must not exceed
3 feet.
Vent hood Combinations:
It is recommended that these ranges be installed
in conjunction with a suitable overhead vent hood.
• Install a hood with at least 1200 CFM above a 48
"
wide range.
• Install a hood with at least 600 CFM above a 30"
or 36" range.
Due to the high heat capacity of this unit, particular attention
should be paid to the hood and ductwork installation to
assure it meets local building codes.
WARNING:
Clearances to horizontal surfaces above the range,
measured to the cooking surface:
• Installations without a hood require 48" minimum
to combustibles.
• A custom hood installation with exposedhorizontal
combustibles surfaces must have an Auto-On feature.
• For other installations with a hood, refer to hood installation
instructions for specific hood clearances.
CAUTION:
These ranges weigh up to 700 pounds. Some disassembly
will reduce the weight considerably. Due to the weight and
size of the range and to reduce the risk of personal injury
or damage to the product:
TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION
OF 36" AND 30" RANGES.
THREE PEOPLE ARE REQUIRED FOR PROPER INSTALLATION
OF 48" RANGES.
WARNING:
All ranges can tip. Injury could result. Install the
supplied Anti-Tip Bracket provided. See instructions
in this manual or with the bracket.
Leak testing of the appliance shall be conducted according
to the manufacturer’s instructions.
Installation must conform with local codes. In the absence
of local codes, the range must comply with the National Fuel
Gas Code, ANSIZ223.1/NFPA 54, latest edition and National
Electrical Code ANSI/NFPA 70 latest addition. In Canada,
installation must conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1 or the current Propane
Installation Code, CAN/CGA-B149.2, and with local codes
where applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest edition and
Canadian Gas Association according to CAN/CGA-1.1 latest
edition.
If sold outside the U.S. and Canada:
WARNING:
If you wish to use this product with
Liquefied Petroleum (LP) gas containing greater than 10%
butane, you must purchase the butane conversion kit
#WB28K10589. To order, please call 1.888.664.8403
or 1.787.276.4051.