GE 00023598 - Manual (Page 16)

1
3. When finished, press the MENU button to confirm. The unit beeps.
NOTE: To skip to the next setting, press the MENU button. To exit setup,
press the FLASH/EXIT button.
Toll Saver
Toll Saver can save you the cost of a call when you access your messages from
another phone:
• If you have new messages, the unit answers after the 2nd ring.
• If you have no new messages, the unit answers after the 5th ring.
You can hang up after the 3rd ring and save the pay telephone or long distance charge.
Setting the Security Code
This feature allows you to change the factory default remote access code used for
remote access to you answerer. The default code is 123.
1. If you just adjusted the Rings to Answer menu, skip to Step 2. If you haven’t
adjusted any other setting, press and release the MENU button until the screen
displays REMOTE ACCESS.
2 The left-most digit, or a (_) sign will flash indicating the unit is ready to accept the
security code entry.
3. Use the keypad to enter a three digit Security Code.
4. After the 3rd and last digit have been entered, press the MENU button to store the
security code and go to the next setting.
NOTE: To skip to the next setting, press the MENU button. To exit setup,
press the FLASH/EXIT button.
NOTE: If you make a mistake, you can use the SKIP or REPEAT
button to move between 1st to rd digit and input the number from
the keypad again.