Motorola digital cellular phone - Manual (Page 5)

5
Safety Information
Important: Read this information before using your wireless
handheld phone.
Exposure to Radio Frequency Signals
Your wireless handheld portable telephone is a low power radio
transmitter and receiver. When it is on, it receives and also sends out
radio frequency (RF) signals.
In August 1996, The Federal Communications Commissions (FCC)
adopted RF exposure guidelines with safety levels for handheld wireless
phones. Those guidelines are consistent with safety standards
previously set by both U.S. and international standards bodies:
• American National Standards Institute (ANSI) C95.1 1992
• National Council on Radiation Protection and Measurement
(NCRP) Report 86 1986
• International Commission on Non-Ionizing Radiation Protection
(ICNIRP) 1996
Those standards were based on comprehensive and periodic evaluations
of the relevant scientific literature. For example, over 120 scientists,
engineers, and physicians from universities, government health
agencies, and industry reviewed the available body of research to
develop the ANSI Standard (C95.1).
The design of your phone complies with the FCC guidelines (and those
standards).
Antenna Care
Use only the supplied or an approved replacement antenna.
Unauthorized antennas, modifications, or attachments could damage the
phone and may violate FCC regulations.
Phone Operation
Normal Operation
Hold the phone as you would any other telephone with the antenna
pointed up and over your shoulder.
TDMA.book Page 5 Thursday, October 29, 1998 9:52 AM