Motorola ComCenter - Manual (Page 11)

Motorola ComCenter
Page 11
APN – When using a GSM/GPRS phone, an APN value is required, which should be
provided by your cellular carrier. This information is required for ComCenter to
automatically configure your Network settings.
3.6.2 Setting up your ISP (Internet Service Provider)…
Figure 12.
This is the Network panel screen in the Palm™ Prefs application. This screen will
not be translated into the language set for ComCenter, as it is not a part of this
application.
This screen lets you configure your ISP information.
Service – The name of this ISP configuration
User Name – The login name for your ISP.
Password – The password for your ISP.
Connection – Set to “Motorola P2K Phone”. ComCenter will automatically reset this
setting if changed.
Phone – The dialup number of your ISP.
Pressing Done will return to the ComCenter application.
Leave the settings in Details… to their defaults.
You can establish a network connection by pressing Connect or start any net enabled
application.
Note: During a data call, you will not be able to receive any incoming calls.
Instead, the caller will either hear the busy signal or be automatically directed to
your voicemail, depending on your service.
While in a data call, if the phone drops the call, or is hung up, the Palm™ data
session must be manually disconnected by going into the Network panel of the
Prefs application. Click the Disconnect button for the ISP to notify the Palm™ to
close the connection.