Introduction, Save this instruction manual for future reference – Mega Catch Mini User Manual

Page 4

Advertising
background image

4

Introduction

ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be

grounded. The grounded electrical cord should be connected to a standard 110-120 volts,, nominal

average 2.0 Amps (4.1 Amps peak), 60 hertz electrical outlet and also must be accessible. If this power

cord should become damaged, a replacement power cord must be purchased from a qualified ENVIRO

dealer. Be careful that the electrical cord is not trapped under the appliance and that it is clear of any hot

surfaces or sharp edges. This unit’s maximum power requirement is 184 watts (322 watts peak).

GLASS: Do not abuse the glass by striking or slamming the door. Do not attempt to operate the stove

with broken glass. The stove uses ceramic glass. Replacement glass must be purchased from an ENVIRO

dealer. Do not attempt to open the door and clean the glass while the unit is in operation or if glass is

hot. To clean the glass, use a soft cotton cloth and mild window cleaner, gas or wood stove glass cleaner,

or take a damp paper towel and dip into the fly ash. This is a very mild abrasive and will not damage the

glass.

FLAMMABLE LIQUIDS: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter

fluid, or similar liquids to start or “freshen up” a fire in the heater. Keep all such liquids well away from

the heater while it is in use.

SMOKE DETECTOR: Smoke detectors should be installed and maintained in the structure when

installing and operating a pellet burning appliance.

OPERATION: The ash pan and door must be closed securely for proper and safe operation of the pellet

stove. Also ensure all gaskets on the door are checked and replaced when necessary.

INSTALLATION: Be sure to maintain the structural integrity of your home when passing a vent through

walls, ceilings, or roofs. It is recommended that the unit be secured into its position in order to avoid any

displacement.

DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT.

DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.

FRESH AIR: Outside fresh air must be connected to all units installed in Mobile and “Air Tight Homes”

(R2000) or where required by local codes. Consider all large air moving devices when installing your unit

and provide room air accordingly. Outside fresh air connection is optional in all other installations. Limited

air for combustion may result in poor performance, smoking and other side effects of poor combustion.

If you have any questions with regards to your stove or the above-mentioned information, please feel

free to contact your local dealer for further clarification and comments.

SINCE SHERWOOD INDUSTRIES LTD. HAS NO CONTROL OVER THE INSTALLATION OF

YOUR STOVE, SHERWOOD INDUSTRIES LTD. GRANTS NO WARRANTY IMPLIED OR STATED

FOR THE INSTALLATION OR MAINTENANCE OF YOUR STOVE. THEREFORE, SHERWOOD

INDUSTRIES LTD. ASSUMES NO RESPONSIBILITY FOR ANY CONSEQUENTIAL DAMAGE(S).

SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

Advertising