Read here, then call us, Troubleshooting tips, Page 15 – Majestic Appliances MJ-9000V User Manual

Page 15

Advertising
background image

Majestic LLC © 01/01/2006

Troubleshooting tips

Read here, then call us

Even though your washer dryer has been carefully designed and constructed, something

may still go amiss with your machine. Before rushing to technician, please check that the

operations listed below have been carried out. In many cases you will save time, money

and a bother. Our statistics show that many calls made to our service representatives

could have been solved with a little more attention to these basic operations.

The washer dryer won’t start

Check that:

• the plug is pushed right into the main socket

• the door is closed tight

• the ON/OFF button has been pressed

The washer dryer won’t fill with water

Check that:

• the tap is open and properly connected to the inlet pipe

• the inlet pipe is not bent

• the inlet pipe is placed at least 80cm/32in. above ground level

The washer dryer drains continuously

Check that:

• the drain hose is not blocked

• the drain hose is placed at least 80 cm/20 inches above ground level but not more than

1 meter/40 inches above ground level.

• the drain pump doesn’t work, the filter net of the drain pump is blocked

There is too much foam in the tub

Check that:

• the detergent being used is meant for automatic machines and not for washing by hand

that the amount used is correct as stated in this manual and not more

The washer dryer vibrates too much when spinning

Check that:

• the shipping bolts have been removed (see installation manual)

• the machine is level

• the washing load is according to the instructions given in this booklet

The washer dryer fills up with water and won’t drain.

Check that:

• The drain hose is only 6” into the stand pipe.

• The drain hose is not clogged

• Standpipe is correct specification

The washer dryer is not drying

Check that:

• the plug is fitted firmly into the main socket

• the door is properly closed

• the wash program knob is in position *

• the drying time knob is not in position 0.

• Use the cotton (blue) hotter cycle with cotton fabrics, and use synthetic (green) cooler cycle for synthetic fabrics.

• the recommendations for the maximum loads and drying times have been followed

Wrinkling

Check that:

• avoid mixing heavy fabrics with light fabrics

• Load your dryer to allow for enough room for clothes to tumble

• Make sure you are not using the cotton drying cycle with synthetic clothes

• the recommendations for the maximum loads and drying times have been followed

Page 15

Advertising