Margaritaville DM3000 - Manual (Page 10)

-8-
NOTE: NEVER SHAKE OR REMOVE A BLENDING JAR DURING OPERATION-
BLADE ASSEMBLY WILL BE DAMAGED
15.
If all three Blending Jars are in use for this cycle, the Ice Chute will rotate to
the left jar and begin the auto Shave-n-Blend ™ function. The unit will shave
ice for the appropriate time (based on the Drink Selection type selected for
that Blending Station). The blending will then start automatically.
NOTE: THE WHITE LED LIGHT WILL BLINK TO INDICATE WHEN
EACH STATION IS IN USE.
16.
When the left jar Shave-n-Blend ™ function is
completed, the Ice Chute will rotate to the center
jar and begin the auto SHAVE-N-BLEND
™ function
based on the Drink Selection type selected for that
Blending Station.
NOTE: AT ANY POINT DURING THE AUTOMATIC CYCLE,
PRESS THE START BUTTON AGAIN TO CANCEL
OPERATION.
17.
When the second function is complete, the Ice Chute will rotate to the fi nal
right position and begin the auto SHAVE-N-BLEND ™ function based on the
Drink Selection type selected for that Blending Station.
NOTE: DO NOT REMOVE ANY OF THE BLENDING JARS FROM THEIR BLENDING
STATIONS UNTIL THE SHAVE-N-BLEND ™ FUNCTION HAS COMPLETED
AT THAT STATION. ONCE AN INDIVIDUAL BLENDING STATION HAS
COMPLETED. THE ICE CHUTE HAS ROTATED AWAY FROM THAT STATION,
THE BLENDING JAR AT THAT STATION CAN BE REMOVED.
18.
After the SHAVE-N-BLEND ™ cycle is complete at all Blending Stations in use,
an Orange light will illuminate to signal that the Ice Chute is about to move
back into the center position.
NOTE: THE ORANGE LIGHT WILL FLASH FROM THE START BUTTON TO SIGNAL
THAT THE ICE CHUTE IS GOING TO RETURN TO THE CENTER POSITION
(HOME).
OP T IONA L :
P e r f e c t i ng you r Fro z e n
C onc o c t ion s
USING THE MANUAL CYCLE
After the Shave-n-Blend ™ cycle is fi nished, you can use the Manual Cycle to
thicken or thin each Blending Jar of drinks to make them just how you like them.
TO THICKEN DRINKS:
• Depress the Manual SHAVE/BLEND toggle switch up or down of the desired
Blending Station for at least two seconds and release if the Chute is not over
the desired station. Ice Chute will rotate to the correct Blending Station and the
Green LED light will fl ash as the Ice Chute is moving.
NOTE: IF THERE ARE NO ACTIONS AFTER THE ICE CHUTE HAS ARRIVED FOR
7 SECONDS AN ORANGE LIGHT WILL FLASH FROM THE START BUTTON
FOR 3 SECONDS TO SIGNAL THAT THE ICE CHUTE IS GOING TO MOVE
BACK TO THE CENTER (HOME) POSITION.